I'm currently working on a corner bench for our dining room. There's a lot of plywood to cut, so I temporarily removed the cnc stuff so I could use my radial arm saw. I made this video to show it still works as a saw and comes in handy when I need to crosscut a bunch of boards between 12 and 17 inches wide.
I think it was an hour or two. I only removed what I had to to get the saw back on and then a little adjustment to cut squarely. If I remember, I will time-lapse converting it back.
Hey Chip,
ReplyDeleteHow long did it take to remove the CNC router stuff?
Regards, Steve
I think it was an hour or two. I only removed what I had to to get the saw back on and then a little adjustment to cut squarely. If I remember, I will time-lapse converting it back.
Delete