Once again, I'm honored to have an instructable featured on the Workshop page of instructables.com today!
This time, I posted a very simple project to make a mini vise for holding small work on the CNC router, or to use free-hand, keeping your hands away from the moving parts.
This simple, low-profile vise was made 100% from material I had lying around the garage. So far, I like using it so much I decided to make it the subject of my latest post.
October 16, 2016 update:
This instructable went out in today's staff picks, pushing it to become the most-viewed of my instructables to date!
Friday, October 14, 2016
Tuesday, October 4, 2016
CNC-Engraved Wood Plaque
The plaque is made from a single poplar board. I found that it worked very well to spray paint the board black before engraving it.
After engraving, I used a number one brush to paint in the grooves.
Subscribe to: Posts (Atom)